568-005 FKM 75 SQUARE CUT RINGS

Part number SV70005 is an AS568-005 black Viton® (FKM) 70 Shore A Square-Cut Ring measuring an inside diameter of 0.101 in (2.57 mm), a cross section of 0.07 in (1.78 mm), and an outside diameter of 0.241 in (6.12 mm). A square-cut ring presents a flat rectangular section that cannot roll or twist in its groove, making it a dependable static seal.

Viton® (FKM) is widely chosen for very low compression set at elevated temperature and outstanding high-temperature capability. Expect good resistance to petroleum oils and fuels, aromatic hydrocarbons, and engine and transmission fluids. The material carries a published service range of -15°F (-26.1°C) to 400°F (204.4°C). The profile itself contributes a rectangular section that will not roll in the groove and a flat contact band that spreads sealing load across a wider area. Note that a square section is less suited to high-speed rotary service, where the larger contact area raises friction and heat.

Common environments for this compound include oil and gas, high-temperature process equipment, and automotive fuel systems.

SV70005 ships individually. Nominal inside diameter is listed as 3/32 inch. Review your operating media and conditions against this specification before installation.