-452 BLACK FKM 70D SQUARE RING

This square-cut ring is supplied in AS568-452 black Viton® (FKM) 70 Shore A with an inside diameter of 11.475 in (291.47 mm), a cross section of 0.275 in (6.99 mm), and an outside diameter of 12.025 in (305.44 mm), catalogued under part number SV70452. It seals with a broad flat contact band instead of the line contact of a round-section ring.

Viton® (FKM) offers the industry benchmark where nitrile reaches its thermal limit and very low compression set at elevated temperature. This material stands up to chlorinated solvents, petroleum oils and fuels, and engine and transmission fluids. Published continuous service range is -15°F (-26.1°C) to 400°F (204.4°C). Verify compatibility before use with hot water and steam or amines. The profile itself contributes a flat contact band that spreads sealing load across a wider area and a rectangular section that will not roll in the groove. Note that a square section is less suited to high-speed rotary service, where the larger contact area raises friction and heat.

Maintenance and OEM teams specify it across chemical processing, semiconductor equipment, and oil and gas.

Stocked as SV70452 and sold individually. Nominal inside diameter is listed as 11 1/2 inch. Review your operating media and conditions against this specification before installation. APG can cross-reference from an existing part number, a drawing or a physical sample if this size is not an exact match.