-456 BLACK FKM 70D SQUARE RING

Part number SV70456 is an AS568-456 black Viton® (FKM) 70 Shore A Square-Cut Ring with an inside diameter of 13.475 in (342.27 mm), a cross section of 0.275 in (6.99 mm), and an outside diameter of 14.025 in (356.24 mm). A square-cut ring provides an economical lathe-cut alternative where a moulded o-ring is not required.

The material holds up against many acids, petroleum oils and fuels, and chlorinated solvents. That behavior comes from the compound itself: Viton® (FKM) offers the industry benchmark where nitrile reaches its thermal limit and very low compression set at elevated temperature. Rated temperature range runs from -15°F (-26.1°C) to 400°F (204.4°C) in continuous service. It should not be specified for service in hot water and steam or low-molecular-weight organic acids. The profile itself contributes a flat contact band that spreads sealing load across a wider area and greater resistance to extrusion than a round section of the same size. Note that a square section is less suited to high-speed rotary service, where the larger contact area raises friction and heat.

You will find this material specified across high-temperature process equipment, semiconductor equipment, and chemical processing.

SV70456 ships individually. Nominal inside diameter is listed as 13 1/2 inch. Confirm chemical compatibility, pressure and temperature against your own application requirements before installing. APG supports cross-referencing from drawings, samples and competitor numbers when a listed size is not an exact fit.