-014 BLACK FKM 90D O-RING

This o-ring is supplied in AS568-014 black Viton® (FKM) 90 Shore A supplied with an inside diameter of 0.489 in (12.42 mm), a cross section of 0.07 in (1.78 mm), and an outside diameter of 0.629 in (15.98 mm), catalogued under part number V90014. It seats in a machined groove and forms a leak-tight barrier when compressed between two mating surfaces.

Expect good resistance to chlorinated solvents, many acids, and aromatic hydrocarbons. That behavior comes from the compound itself: Viton® (FKM) is widely chosen for the industry benchmark where nitrile reaches its thermal limit and very low compression set at elevated temperature. The material carries a published service range of -15°F (-26.1°C) to 400°F (204.4°C). Verify compatibility before use with hot water and steam or ketones and esters.

It sees regular use in oil and gas, chemical processing, and automotive fuel systems.

Reference part number V90014 when ordering; the item is sold individually. Unit weight is approximately 0.217 g and nominal inside diameter is listed as 1/2 inch. As always, verify media compatibility and operating conditions against the requirements of your specific application. APG supports cross-referencing from drawings, samples and competitor numbers when a listed size is not an exact fit.