2.4MM CS X 19.5MM ID BLACK BUNA 70D

Ordered as H2.4X19.5, this is a black Buna-N (Nitrile) 70 Shore A O-Ring measuring an inside diameter of 19.5 mm (0.768 in), a cross section of 2.4 mm (0.094 in), and an outside diameter of 24.3 mm (0.96 in). The o-ring creates a positive seal at flange, piston and rod interfaces without added hardware.

Buna-N (Nitrile) is valued for low compression set under sustained load, reliable performance in both static and dynamic service. The material holds up against water, petroleum-based oils, and hydraulic fluids. Service temperature is rated from -40°F (-40°C) through 250°F (121.1°C).

Typical settings include construction equipment, hydraulic and pneumatic systems, and agricultural equipment.

This item is sold individually under part number H2.4X19.5. As always, verify media compatibility and operating conditions against the requirements of your specific application. Not finding the exact configuration you need? APG cross-references from prints, samples and competitor part numbers.