1MM CS X 25MM ID BLACK BUNA 70D

APG stocks the H1X25, a black Buna-N (Nitrile) 70 Shore A O-Ring with an inside diameter of 25 mm (0.984 in), a cross section of 1 mm (0.039 in), and an outside diameter of 27 mm (1.06 in). An o-ring creates a positive seal at flange, piston and rod interfaces without added hardware.

Buna-N (Nitrile) is specified here for low compression set under sustained load, reliable performance in both static and dynamic service. It resists petroleum-based oils, greases and lubricants, and water. Continuous operating temperature is published at -40°F (-40°C) to 250°F (121.1°C). It is not the right choice where ozone and direct sunlight or ketones are present.

Common environments for this compound include fluid power, construction equipment, and automotive.

H1X25 ships individually. Unit weight is approximately 0.0801 g. Review your operating media and conditions against this specification before installation. APG supports cross-referencing from drawings, samples and competitor numbers when a listed size is not an exact fit.