1MM CS X 2.7MM ID BLACK BUNA 70D

This o-ring is supplied in black Buna-N (Nitrile) 70 Shore A built to an inside diameter of 2.7 mm (0.106 in), a cross section of 1 mm (0.039 in), and an outside diameter of 4.7 mm (0.19 in), catalogued under part number H1X2.7. It creates a positive seal at flange, piston and rod interfaces without added hardware.

The material holds up against propane and butane, water, and hydraulic fluids. Buna-N (Nitrile) is valued for strong abrasion and tear resistance, low compression set under sustained load. Rated temperature range runs from -40°F (-40°C) to 250°F (121.1°C) in continuous service. Verify compatibility before use with ozone and direct sunlight or polar solvents.

Common environments for this compound include automotive, fluid power, and general industrial maintenance.

Order part number H1X2.7, sold individually. Unit weight is approximately 0.0001 g. Application requirements vary, so validate compatibility with your process conditions prior to installation. APG can cross-reference from an existing part number, a drawing or a physical sample if this size is not an exact match.