1.5MM CS X 68MM ID BLACK BUNA 70D

APG stocks the H1.5X68, a black Buna-N (Nitrile) 70 Shore A O-Ring built to an inside diameter of 68 mm (2.677 in), a cross section of 1.5 mm (0.059 in), and an outside diameter of 71 mm (2.8 in). An o-ring seats in a machined groove and forms a leak-tight barrier when compressed between two mating surfaces.

Buna-N (Nitrile) is specified here for low compression set under sustained load and most widely specified general-purpose sealing elastomer. This material stands up to propane and butane, petroleum-based oils, and water. Continuous operating temperature is published at -40°F (-40°C) to 250°F (121.1°C). Exposure to ozone and direct sunlight or polar solvents will shorten service life.

Common environments for this compound include fluid power, agricultural equipment, and construction equipment.

Stocked as H1.5X68 and sold individually. Unit weight is approximately 0.0005 g. As always, verify media compatibility and operating conditions against the requirements of your specific application.