2MM CS X 12MM ID RED SILICONE 70D

Part number S2X12 is a red Silicone 70 Shore A O-Ring with an inside diameter of 12 mm (0.472 in), a cross section of 2 mm (0.079 in), and an outside diameter of 16 mm (0.63 in). An o-ring creates a positive seal at flange, piston and rod interfaces without added hardware.

Silicone is widely chosen for very good compression set resistance across its range and excellent electrical insulating properties. This material stands up to dry heat, extreme heat and cold, and ozone and UV exposure. The material carries a published service range of -80°F (-62.2°C) to 450°F (232.2°C). It is not the right choice where hydrocarbon fuels and oils or abrasive dynamic service are present.

The compound meets FDA requirements for food contact. Typical settings include electronics and electrical enclosures, medical devices, and sanitary process lines.

Reference part number S2X12 when ordering; the item is sold individually. Unit weight is approximately 0.192 g. Review your operating media and conditions against this specification before installation. APG can cross-reference from an existing part number, a drawing or a physical sample if this size is not an exact match.