1MM CS X 18MM ID RED SILICONE 70D

Part number S1X18 is a red Silicone 70 Shore A O-Ring measuring an inside diameter of 18 mm (0.709 in), a cross section of 1 mm (0.039 in), and an outside diameter of 20 mm (0.79 in). An o-ring creates a positive seal at flange, piston and rod interfaces without added hardware.

Silicone is specified here for flexibility that holds at very low temperatures and very good compression set resistance across its range. This material stands up to many oxidizing chemicals, weathering, and extreme heat and cold. Rated temperature range runs from -80°F (-62.2°C) to 450°F (232.2°C) in continuous service. Verify compatibility before use with abrasive dynamic service or steam above its rated range.

The compound meets FDA requirements for food contact. Common environments for this compound include ovens and heated equipment, electronics and electrical enclosures, and food and beverage processing.

S1X18 ships individually. Unit weight is approximately 0.0678 g. As always, verify media compatibility and operating conditions against the requirements of your specific application. Not finding the exact configuration you need? APG cross-references from prints, samples and competitor part numbers.