2.5MM CS X 19MM ID RED SILICONE 70D

This o-ring is supplied in red Silicone 70 Shore A built to an inside diameter of 19 mm (0.748 in), a cross section of 2.5 mm (0.098 in), and an outside diameter of 24 mm (0.94 in), catalogued under part number S2.5X19. It provides a reliable static or dynamic seal by deforming into its gland under assembly load.

The compound resists extreme heat and cold, dry heat, and weathering. Silicone offers flexibility that holds at very low temperatures and very good compression set resistance across its range. Continuous operating temperature is published at -80°F (-62.2°C) to 450°F (232.2°C). Applications involving steam above its rated range or abrasive dynamic service call for a different compound.

The compound meets FDA requirements for food contact. Typical settings include pharmaceutical manufacturing, electronics and electrical enclosures, and ovens and heated equipment.

This item is sold individually under part number S2.5X19. Unit weight is approximately 0.458 g. Check the compound against your process media, pressure and temperature before committing to a design. Not finding the exact configuration you need? APG cross-references from prints, samples and competitor part numbers.