1MM CS X 20MM ID RED SILICONE 70D

Part number S1X20 is a red Silicone 70 Shore A O-Ring supplied with an inside diameter of 20 mm (0.787 in), a cross section of 1 mm (0.039 in), and an outside diameter of 22 mm (0.87 in). An o-ring provides a reliable static or dynamic seal by deforming into its gland under assembly load.

Expect good resistance to weathering, extreme heat and cold, and many oxidizing chemicals. Silicone is valued for an exceptionally wide service temperature range, physiological inertness and low toxicity. Rated temperature range runs from -80°F (-62.2°C) to 450°F (232.2°C) in continuous service. Verify compatibility before use with concentrated acids or hydrocarbon fuels and oils.

The compound meets FDA requirements for food contact. Typical settings include sanitary process lines, electronics and electrical enclosures, and medical devices.

Stocked as S1X20 and sold individually. Unit weight is approximately 0.069 g. Review your operating media and conditions against this specification before installation. APG can cross-reference from an existing part number, a drawing or a physical sample if this size is not an exact match.