3MM CS X 41MM ID RED SILICONE 70D

This o-ring is supplied in red Silicone 70 Shore A with an inside diameter of 41 mm (1.614 in), a cross section of 3 mm (0.118 in), and an outside diameter of 47 mm (1.85 in), catalogued under part number S3X41. It creates a positive seal at flange, piston and rod interfaces without added hardware.

This material stands up to weathering, ozone and UV exposure, and dry heat. That behavior comes from the compound itself: Silicone is known for very good compression set resistance across its range, physiological inertness and low toxicity. The material carries a published service range of -80°F (-62.2°C) to 450°F (232.2°C). Verify compatibility before use with abrasive dynamic service or steam above its rated range.

This o-ring meets FDA requirements for food contact. Typical settings include ovens and heated equipment, sanitary process lines, and food and beverage processing.

Reference part number S3X41 when ordering; the item is sold individually. Unit weight is approximately 1.3596 g. Check the compound against your process media, pressure and temperature before committing to a design.